TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2417-05 Ether Injection Control Sole- Test Step 1: Verify Diagnostic
noid Current Below Normal Code
Code is Active.
Continued
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct the problem and verify diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Remove ether bottle
(WP 0048).
2. Perform Ether Injection Sole-
2417-05 Active - Proceed to Test
noid Override Test (WP 0021)
Step 2.
and check if diagnostic code
2417-05 becomes active.
Test Step 2: Test Solenoid Con-
trol Circuit.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor EN-C20 (WP 0018,
Figure 136) from ether valve
solenoid.
3. Install jumper wire between
ether valve solenoid harness
connector EN-C20 (WP 0018,
Figure 136) terminal 1 and
ground.
4. Turn ignition switch to ON
position (TM 5-2410-240-10).
5. Perform Ether Injection Sole-
2417-05 Remains Active - Pro-
noid Override Test (WP 0021)
ceed to Test Step 3.
and check if diagnostic code
2417-06 Becomes Active - ECM
2417-06 becomes active.
and control circuit tests OK, pro-
ceed to step 6.
6. Remove jumper wire from EN-
C20 (WP 0018, Figure 136)
terminal 1 and ground.
0019-119