TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2417-06 Ether Injection Control Sole- 7. Using a digital multimeter (WP
Continuity - Engine control wiring
noid Current Above Normal Code
0283), test for continuity
harness is shorted. Replace
Continued
between harness connector
engine control wiring harness
EN-C13 (WP 0018,
(WP 0052). Verify proper operation
Figure 130) terminal 29 all
of machine (TM 5-2410-240-10).
other circuits in harness con-
No Continuity - Proceed to step 8.
nector EN-C13 (WP 0018,
Figure 130).
8. Using a digital multimeter (WP
Continuity - Engine control wiring
0283), test for continuity
harness is shorted. Replace
between harness connector
engine control wiring harness
EN-C13 (WP 0018,
(WP 0052). Verify proper operation
Figure 130) terminal 29 and
of machine (TM 5-2410-240-10).
ground.
No Continuity - Faulty ECM.
Replace engine ECM (WP 0049).
Connect EN-C20 (WP 0018,
Figure 136) to ether valve sole-
noid.
Verify proper operation of machine
(TM 5-2410-240-10).
N OT E
E172-1 Event Codes High Air Filter
Restriction - Warning
This code is generated only when engine has been running for
three minutes and restricted air flow has been detected. This
code will be reset when ignition switch is turned to OFF position
(TM 5-2410-240-10).
1. Using Messenger (WP 0015),
E172-1 Present - Proceed to step
verify presence of event code
2.
E172-1.
2. Inspect air inlet system for
Air Inlet System is Blocked or
damage, blockage, and clean- Dirty - Clean and remove block-
liness (WP 0028).
age from air inlet system compo-
nents (WP 0028).
N OT E
E172-2 Event Codes High Air Filter
Restriction Code - Warning
This code is generated only when engine has been running for
three minutes and restricted air flow has been detected. This
code will be reset when ignition switch is turned to OFF position
(TM 5-2410-240-10).
E172-2 Present - Proceed to step
1. Using Messenger (WP 0015),
2.
verify presence of event code
E172-2.