TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
2688-08 Right Drive Motor
21. Connect MSD (WP 0016). Select
2688-08 Code Active - Replace
Speed Sensor #2 Abnormal
machine control ECM and check
machine ECM (WP 0147, WP 0149).
Frequency, Pulse Width, or
for diagnostic codes (WP 0013).
Verify proper operation of machine
Period - Continued
(TM 5-2410-240-10).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
Add fuel - (TM 5-2410-240-10).
E0119 Low Fuel Level
Conditions Which Generate This
Code:
The machine electronic control mod-
ule (ECM) monitors the following:
Fuel level is excessively low.
E0179 Alternator Not Charg-
Inspect charging system for a loose or
Test charging system - (WP 0030)
ing
a missing alternator belt, a loose or
for a loose or missing alternator belt, a
damaged alternator, loose or corroded
loose or damaged alternator, loose or
battery cables, and failed batteries.
corroded battery cables, and failed
batteries.
E0441 Idle Elevated in Order
This feature may be used to compen-
to Increase Battery Voltage
sate for electrical accessories that
may have been added. The machine
electronic control module (ECM) mon-
itors the following:
a. Engine is running and low
battery voltage is detected.
b. Verify battery and charging
Charging System is Suspected -
system is functioning.
Refer to alternator will not charge (WP
Battery is suspected - Refer to bat-
tery low voltage (WP 0030).
E0491 Incorrect Number of
Machine ECM has incorrect/incom-
Install Correct Software - Flash
Valve ECM Detected
patible software installed.
ECM with correct software (WP
Verify machine ECM software (WP
N OT E
Perform this test only if condition is active.