TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
E0577 Engine Ramp Rate
4. Verify that symptom is active.
Symptom Not Active - Operate
Limited Due to Cold Hydrau-
machine and document when condi-
lic Oil - Continued
tion occurs.
E0679 Idle Elevated in Order
Symptom Active - Perform Final
to Increase Engine Coolant
Hydrostatic Speed Test (WP 0031).
Temperature - Continued
E0695 Unexpected Motor
Speed Detection Disabled -
Continued
E0696 Opposite Machine
1. Machine requires an immediate,
Movement Commands Dis-
safe shutdown in order to avoid
abled
damage to machine or injury to
personnel around the machine.
The problem that caused event
will need to be corrected before
machine operation can resume.
2. This active only event indicates
that unexpected speed detection
system is disabled due to a sys-
tem fault.
3. Connect MSD (WP 0016). Check
Diagnostic Codes Active - Refer to
for active diagnostic codes (WP
(WP 0013) and repair active codes
first.
Diagnostic Codes are Not Active -
Proceed to step 4.
4. Verify that symptom is active.
Symptom Not Active - Operate
machine and document when condi-
tion occurs.
Symptom Active - Perform Final
Hydrostatic Speed Test (WP 0031).
E0875 Low System Voltage
Inspect the charging system for loose
Verify Charging System is Operat-
or missing alternator belt, loose or
ing Correctly - Refer to battery low
damaged alternator, loose or corroded
voltage (WP 0030).
battery cables and failed batteries
E0876 High System Voltage
Verify charging system is operating
Perform Charging System Test -
correctly.
E878 High Hydraulic Oil
1. Turn ignition switch and battery
Temperature
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
