TM 5-2410-240-23-1
0021
Table 1. Cab Troubleshooting Without Codes. - Continued.
0021
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. All Front and Rear Flood Lamps
8. Using a digital multimeter,
Voltage Within 18 to 26 Volts -
Do Not Work - Continued
measure for voltage (WP
Proceed to Test Step 13.
0283) between lamp relay
Voltage Not Within 18 to 26
fuse top terminal B4 (Figure
Volts - Turn LH wiper switch to
36) and ground.
OFF position (TM 5-2410-240-10).
Turn battery disconnect switch to
OFF position (TM 5-2410-240-10).
Replace flood lamp relay (WP
0018, Figure 55).
Connect C-C30 (WP 0018, Figure
27) on flood lamp relay #1 (WP
0018, Figure 54).
For D6K Dozer with Ripper, install
ripper operation control handle
(WP 0218). For D6K Dozer with
Winch, install winch operation
control handle (WP 0217).
Disconnect C-C4 (WP 0018,
Figure 16) from LH wiper switch
(WP 0018, Figure 64).
Connect C-C4 (WP 0018, Figure
16) from flood lamp switch (WP
0018, Figure 60).
Connect C-C6 (WP 0018, Figure
18) on LH wiper switch (WP 0018,
Figure 64).
Install front control panel on right
side console (WP 0217).
Install fuse panel side cover from
machine (TM 5-2410-240-10).
Install fuse panel front cover on
machine (TM 5-2410-240-10).
Install new lamp relay fuse on fuse
block.
Verify proper operation of flood
lamps (TM 5-2410-240-10).
0021-93