TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1699-03 Joystick Position Sensor
22. Using digital multimeter, test
No Continuity - Replace platform
(Forward/Reverse) Voltage Above
for continuity (WP 0283)
wiring harness (WP 0150, WP
Normal - Continued
between harness connector
0155). Ensure all harness connec-
PL-C5 (WP 0018, Figure 218)
tors are reconnected. Verify proper
terminal 26 and harness con-
operation of machine (TM 5-2410-
nector PL-C1 (WP 0018, Fig-
240-10).
ure 214) terminal 42.
Continuity - Proceed to step 23.
23. Using digital multimeter, test
No Continuity - Replace machine
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 26 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform har-
ness (WP 0150, WP 0155).
N OT E
1699-04 Joystick Position Sensor
(Forward/Reverse) Voltage Below
Always inspect harness connectors that are involved in circuit.
Normal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C5 (WP 0018, Figure
71) from transmission control
handle base.
4. Turn battery disconnect switch
and ignition switch to ON posi-
tion (TM 5-2410-240-10).
5. Using digital multimeter (WP
Voltage Less Than Specified
0283), measure 10-volt supply
Range - Proceed to step 7.
circuit between harness con-
Voltage Within Specified Range
nector CA-C5 (WP 0018, Fig-
- Proceed to step 6.
ure 71) terminal 1 and 2.
There should be approximately
10 volts 0.5 volts.