TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0358-06 Implement Pilot
8. Using digital multimeter (WP
No Continuity on Test Point -
Pressure Supply Current
0283), test for continuity between
Replace machine ECM: with Ripper
Above Normal - Continued
PL-C5 terminal 2 (WP 0018, Fig-
(WP 0147); with Winch (WP 0149).
ure 218) and ground.
Connect platform wiring harness con-
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C17 on implement pilot
pressure supply solenoid: with Ripper
(WP 0018, Figure 90); with Winch
(WP 0018, Figure 261).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
Continuity on Test Point - Replace
platform wiring harness: with Ripper
(WP 0150); with Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C17 on implement pilot
pressure supply solenoid: with Ripper
(WP 0018, Figure 90); with Winch
(WP 0018, Figure 261).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 0358-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 0358-06 is not active.
Code 0358-06 Not Active - Trouble-
shooting complete.
0023-27