TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0358-05 Implement Pilot
Test Step 4. Test H708-OR On/Off
Pressure Supply Current
Driver Return Circuit for High
Below Normal - Continued
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace machine ECM: with Ripper
between PL-C5 terminal 4 (WP
(WP 0147); with Winch (WP 0149).
0018, Figure 218) and PL-C18
Connect platform wiring harness con-
terminal 18 (WP 0018, Figure
nector PL-C18 (WP 0018, Figure 226)
226).
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C17 on implement pilot
pressure supply solenoid: with Ripper
(WP 0018, Figure 90) or with Winch
(WP 0018, Figure 261).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness: with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C17 on implement pilot
pressure supply solenoid: with Ripper
(WP 0018, Figure 90) or with Winch
(WP 0018, Figure 261).
For D6K with Ripper, install rear
plates on machine (WP 0196). For
D6K with Winch, install rear bottom
guards on machine (WP 0156).
Proceed to step 2.
2. Using MSD (WP 0016), select
Code 0358-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 0358-05 is not active.
Code 0358-05 Not Active - Trouble-
shooting complete.
0023-22