TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0497-06 Blade Tilt Right
8. Using digital multimeter (WP
No Continuity on Test Point -
Solenoid Current Above
0283), test for continuity between
Replace machine ECM: with Ripper
Normal - Continued
PL-C4 terminal 61 (WP 0018, Fig-
(WP 0147); with Winch (WP 0149).
ure 217) and ground.
Connect platform wiring harness con-
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C20 on blade tilt right sole-
noid: with Ripper (WP 0018, Figure
93); with Winch (WP 0018, Figure
264).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
Continuity on Test Point - Replace
platform wiring harness: with Ripper
(WP 0150); with Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C20 on blade tilt right sole-
noid: with Ripper (WP 0018, Figure
93); with Winch (WP 0018, Figure
264).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 0497-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 0497-06 is not active.
Code 0497-06 Not Active - Trouble-
shooting complete.
0023-39