TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0497-06 Blade Tilt Right
6. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Current Above
0283), test for continuity between
Proceed to step 7.
Normal - Continued
PL-C4 terminal 61 (WP 0018, Fig-
Continuity on One or More Test
ure 217) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C20 on blade tilt right sole-
noid: with Ripper (WP 0018, Figure
93); with Winch (WP 0018, Figure
264).
For D6K with Ripper, install rear
plates on machine (WP 0196). For
D6K with Winch, install rear bottom
guards on machine (WP 0156).
Proceed to step 9.
7. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 8.
PL-C4 terminal 61 (WP 0018, Fig-
Continuity on One or More Test
ure 217) and all circuits in PL-C2
Points - Replace platform wiring har-
(WP 0018, Figure 215).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C20 on blade tilt right sole-
noid: with Ripper (WP 0018, Figure
93); with Winch (WP 0018, Figure
264).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
0023-38