TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-04 Winch Spool In
10. Check for active code 1884-04 in
Code 1884-04 Remains Active - Pro-
Solenoid Voltage Below Nor-
machine control D6K ECM (WP
ceed to Test Step 2.
mal - Continued
Code 1884-04 Becomes Inactive -
Disconnect pump wiring harness con-
nector PH-C8 from reel-out solenoid.
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Replace reel-in solenoid (WP 0132).
Proceed to step 11.
11. Using MSD (WP 0016), select
Code 1884-04 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1884-04 is not active.
Code 1884-04 Not Active - Trouble-
shooting complete.
Test Step 2. Test J807-BK Reel-In
Solenoid Return Circuit for Short to
Other Circuits in Pump Wiring Har-
ness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Disconnect pump wiring harness
connector PH-C8 from reel-out
solenoid (WP 0018, Figure 212).
3. Connect pump wiring harness
connector PH-C9 on reel-out
solenoid (WP 0018, Figure 213)
(WP 0267).
4. Remove right side debris guards
from machine (WP 0187).
5. Disconnect pump wiring harness
connector PH-C1 (WP 0018, Fig-
ure 205) from engine wiring har-
ness connector EN-C21 (WP
0018, Figure 137) (WP 0046).
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PH-C1 terminal 6 and all other cir-
Continuity on One or More Test
cuits in PH-C1 (WP 0018, Figure
Points - Replace pump wiring har-
205).
ness (WP 0046).
Proceed to step 8.
0023-86