TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-03 Winch Spool In
Test Step 4. Test F869-PK Reel-In
Solenoid Voltage Above Nor- Solenoid Supply Circuit for Short
mal - Continued
to Other Voltage Source in Platform
Wiring Harness.
1. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
2. Using digital multimeter (WP
Voltage Greater Than 0.3 Volts -
0283), measure for voltage
Replace platform wiring harness (WP
between PL-C2 terminal 26 (WP
0155).
0018, Figure 215) and ground.
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Install right side debris guards (WP
0187).
Proceed to step 3.
Voltage 0.3 Volts or Lower - Replace
equipment ECM (WP 0148).
Connect platform wiring harness con-
nector PL-C5 (WP 0018, Figure 218)
on ECM J2 (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1 (WP 0149).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect engine wiring harness con-
nector EN-C50 (WP 0018, Figure
140) on platform wiring harness con-
nector PL-C32 (WP 0018, Figure 232)
(WP 0046).
Install right side debris guards (WP
0187).
Install front floor plate (WP 0205).
Proceed to step 3.
3. Using MSD (WP 0016), select
Code 1884-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1884-03 is not active.
Code 1884-03 Not Active - Trouble-
shooting complete.
0023-84