TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2212-06 Auxiliary Valve #1
8. Using digital multimeter (WP
No Continuity on Test Point -
Port A Solenoid Current
0283), test for continuity between
Replace equipment ECM (WP 0148).
Above Normal - Continued
PL-C2 terminal 40 (WP 0018, Fig-
Connect platform wiring harness con-
ure 215) and ground.
nector PL-C5 (WP 0018, Figure 218)
on ECM J2: with Ripper (WP 0147);
with Winch (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1: with Ripper (WP 0147);
with Winch (WP 0149).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C2 on auxiliary valve #1
port A solenoid (WP 0018, Figure 82).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
Continuity on Test Point - Replace
platform wiring harness: with Ripper
(WP 0150); with Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C2 on auxiliary valve #1
port A solenoid (WP 0018, Figure 82).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 2212-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2212-06 is not active.
Code 2212-06 Not Active - Trouble-
shooting complete.
0023-204