TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2440-05 Winch Brake Sole-
Test Step 3. Test 956-BR Winch
noid Current Below Normal -
Brake Solenoid Circuit for High
Continued
Resistance or Open in Platform
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove jumper wire from PL-C33
terminal 5 and terminal 6 (WP
0018, Figure 233).
3. Disconnect platform wiring har-
ness connector PL-C5 (WP 0018,
Figure 218) from ECM J2 (WP
0149).
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Proceed to Test Step 4.
between PL-C5 terminal 5 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 218) and PL-C33
Replace platform wiring harness (WP
terminal 5 (WP 0018, Figure 233).
0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 2440-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2440-05 is not active.
Code 2440-05 Not Active - Trouble-
shooting complete.
0023-232