TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2440-05 Winch Brake Sole-
Test Step 4. Test H708-OR On/Off
noid Current Below Normal -
Driver Return Circuit for High
Continued
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace machine ECM (WP 0149).
between PL-C5 terminal 4 (WP
Connect platform wiring harness con-
0018, Figure 218) and PL-C33
nector PL-C2 (WP 0018, Figure 215)
terminal 6 (WP 0018, Figure 233).
on equipment ECM (WP 0148).
Connect winch solenoid wiring har-
ness connector WC-C2 (WP 0018,
Figure 249) on platform wiring har-
ness connector PL-C33 (WP 0018,
Figure 233) (WP 0137).
Install right rear access cover on
machine (WP 0191).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness (WP
0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 2.
2. Using MSD (WP 0016), select
Code 2440-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2440-05 is not active.
Code 2440-05 Not Active - Trouble-
shooting complete.
0023-233