TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2440-06 Winch Brake Sole-
8. Using digital multimeter (WP
No Continuity on Test Point -
noid Current Above Normal -
0283), test for continuity between
Replace machine ECM (WP 0149).
Continued
PL-C5 terminal 5 (WP 0018, Fig-
Connect platform wiring harness con-
ure 218) and ground.
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect winch solenoid wiring har-
ness connector WC-C2 (WP 0018,
Figure 249) on platform wiring har-
ness connector PL-C33 (WP 0018,
Figure 233) (WP 0137).
Install right rear access cover on
machine (WP 0191).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
Continuity on Test Point - Replace
platform wiring harness (WP 0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 2440-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2440-06 is not active.
Code 2440-06 Not Active - Trouble-
shooting complete.
Test Step 4. Test 956-BR Winch
Brake Solenoid Circuit for Short to
Other Circuits in WInch Wiring Har-
ness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove winch from machine (WP
0265).
0023-238
