TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-03 Winch Motor Pres-
3. Connect jumper wire between
sure Sensor Voltage Above
WC-C4 terminal B and terminal C
Normal - Continued
(WP 0018, Figure 251).
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
5. Check for active code 2441-03 or
Code 2441-03 Remains Active - Pro-
2441-04 in machine control D6K
ceed to Test Step 5.
ECM (WP 0016).
Code 2441-03 Becomes Inactive
and 2441-04 Becomes Active - Turn
ignition switch and battery disconnect
switch to OFF position (TM 5-2410-
240-10).
Remove jumper wire from WC-C4 ter-
minal B and terminal C (WP 0018,
Figure 251).
Replace winch oil pressure sensor
(WP 0136).
Proceed to step 6.
6. Using MSD (WP 0016), select
Code 2441-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-03 is not active.
Code 2441-03 Not Active - Trouble-
shooting complete.
Test Step 5. Test J764-BR 10-Volt
Sensor Return Circuit for Open in
Winch Solenoid Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove right rear access cover
from machine (WP 0191).
3. Disconnect winch solenoid wiring
harness connector WC-C2 (WP
0018, Figure 249) from platform
wiring harness connector PL-C33
(WP 0018, Figure 233) (WP
0137).
0023-242