TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-03 Winch Motor Pres-
Test Step 3. Test 852-GN Winch
sure Sensor Voltage Above
Pressure Sensor Circuit Function
Normal - Continued
in Machine ECM.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Connect jumper wire between
WC-C4 terminal C (WP 0018, Fig-
ure 251) and ground.
3. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
4. Check for active code 2441-03 or
Code 2441-03 Remains Active -
2441-04 in machine control D6K
Turn ignition switch and battery dis-
ECM (WP 0016).
connect switch to OFF position (TM 5-
2410-240-10).
Remove jumper wire from WC-C4 ter-
minal C (WP 0018, Figure 251) and
ground.
Replace machine ECM (WP 0149).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 5.
Code 2441-03 Becomes Inactive
and 2441-04 Becomes Active - Pro-
ceed to Test Step 4.
Code 2441-03 Active - Repeat trou-
5. Using MSD (WP 0016), select
bleshooting code from the beginning.
machine control D6K ECM and
verify 2441-03 is not active.
Code 2441-03 Not Active - Trouble-
shooting complete.
Test Step 4. Test J764-BR 10-Volt
Sensor Return Circuit Function in
Machine ECM.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-2410-240-10).
2. Remove jumper wire from WC-C4
terminal C (WP 0018, Figure 251)
and ground.
0023-241