TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-03 Winch Motor Pres-
3. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
sure Sensor Voltage Above
0283), measure resistance
Replace machine ECM (WP 0149).
Normal - Continued
between PL-C4 terminal 69 (WP
Connect winch solenoid wiring har-
0018, Figure 217) and PL-C33
ness connector WC-C2 (WP 0018,
terminal 9 (WP 0018, Figure 233).
Figure 249) on platform wiring har-
ness connector PL-C33 (WP 0018,
Figure 233) (WP 0137).
Install right rear access cover on
machine (WP 0191).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 4.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness (WP
0155).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 4.
4. Using MSD (WP 0016), select
Code 2441-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-03 is not active.
Code 2441-03 Not Active - Trouble-
shooting complete.
Test Step 9. Test 852-GN Winch
Pressure Sensor Circuit for Open
in Winch Solenoid Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Connect jumper wire between
WC-C4 terminal B and terminal C
(WP 0018, Figure 251).
3. Remove right rear access cover
from machine (WP 0191).
0023-246
