TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-03 Winch Motor Pres-
4. Using digital multimeter (WP
No Continuity on Any Test Points -
sure Sensor Voltage Above
0283), test for continuity between
Proceed to Test Step 12.
Normal - Continued
WC-C2 terminal 8 and all other
Continuity on One or More Test
circuits in WC-C2 (WP 0018, Fig-
Points - Replace winch solenoid wir-
ure 249).
ing harness (WP 0137).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 2441-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-03 is not active.
Code 2441-03 Not Active - Trouble-
shooting complete.
Test Step 12. Test 852-GN Winch
Pressure Sensor Circuit for Short
to Other Circuits in Platform Wiring
Harness.
1. Disconnect platform wiring har-
ness connector PL-C5 (WP 0018,
Figure 218) from ECM J2 (WP
0149).
2. Disconnect platform wiring har-
ness connector PL-C4 (WP 0018,
Figure 217) from ECM J1 (WP
0149).
3. Disconnect platform wiring har-
ness connector PL-C2 (WP 0018,
Figure 215) from equipment ECM
(WP 0148).
4. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 5.
PL-C5 terminal 50 and all other
Continuity on One or More Test
circuits in PL-C5 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 218).
ness (WP 0155).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 7.
0023-249