TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-03 Winch Motor Pres-
5. Using digital multimeter (WP
No Continuity on Any Test Points -
sure Sensor Voltage Above
0283), test for continuity between
Proceed to step 6.
Normal - Continued
PL-C5 terminal 50 (WP 0018, Fig-
Continuity on One or More Test
ure 218) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness (WP 0155).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 7.
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to Test Step 13.
PL-C5 terminal 50 (WP 0018, Fig-
Continuity on One or More Test
ure 218) and all circuits in PL-C2
Points - Replace platform wiring har-
(WP 0018, Figure 215).
ness (WP 0155).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 7.
7. Using MSD (WP 0016), select
Code 2441-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-03 is not active.
Code 2441-03 Not Active - Trouble-
shooting complete.
0023-250