TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-04 Winch Motor Pres-
7. Using digital multimeter (WP
No Continuity on Test Point -
sure Sensor Voltage Below
0283), test for continuity between
Replace machine ECM (WP 0149).
Normal - Continued
PL-C5 terminal 50 (WP 0018, Fig-
Connect platform wiring harness con-
ure 218) and ground.
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect winch solenoid wiring har-
ness connector WC-C2 (WP 0018,
Figure 249) on platform wiring har-
ness connector PL-C33 (WP 0018,
Figure 233) (WP 0137).
Install right rear access cover on
machine (WP 0191).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 8.
Continuity on Test Point - Replace
platform wiring harness (WP 0155).
Connect winch solenoid wiring har-
ness connector WC-C4 on winch oil
pressure sensor (WP 0018, Figure
251) (WP 0136).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 2441-04 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-04 is not active.
Code 2441-04 Not Active - Trouble-
shooting complete.
0023-255