TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
2441-08 Winch Motor Pres-
sure Sensor Abnormal Fre-
Always inspect harness connectors thatare involved in the circuit. Poor
quency, Pulse Width Or
connections can often be the cause of an electrical circuit problem. Ver-
Period
ify that all connections in circuit are clean and secure, and connections
are in good condition. If problem with connection is found, correct the
problem and verify diagnostic code is active before performing this pro-
cedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
Test Step 1. Inspect Winch Sole-
noid Wiring WC-C4 Harness Con-
nector and Winch Oil Pressure
Sensor.
1. Connect MSD (WP 0016). Select
machine control D6K ECM and
verify 2441-08 is active.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Remove rear bottom guards from
machine (WP 0156).
4. Disconnect winch solenoid wiring
harness connector WC-C4 from
winch oil pressure sensor (WP
0018, Figure 251) (WP 0136).
5. Inspect winch solenoid wiring
Winch Solenoid Wiring WC-C4 Har-
WC-C4 harness connector (WP
ness Connector Damaged - Replace
0018, Figure 251) and winch oil
winch solenoid wiring harness (WP
pressure sensor connector for
0137).
damage (WP 0283).
Proceed to step 6.
Winch Oil Pressure Sensor Con-
nector Damaged - Replace winch oil
pressure sensor (WP 0136).
Proceed to step 6.
No Problem Found - Connect winch
solenoid wiring harness connector
WC-C4 on winch oil pressure sensor
(WP 0018, Figure 251) (WP 0136).
Proceed to Test Step 2.