TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-08 Winch Motor Pres-
2. Turn battery disconnect switch
sure Sensor Abnormal Fre-
and ignition switch to ON position
quency, Pulse Width Or
(TM 5-2410-240-10).
Period - Continued
3. Check for active code 2441-03 in
Code 2441-03 Becomes Active -
machine control D6K ECM (WP
Proceed to Test Step 6.
Code 2441-03 Does Not Become
Active - Proceed to Test Step 7.
Test Step 6. Test 852 GN Winch
Pressure Sensor Circuit Function
in Machine ECM.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Connect jumper wire between
WC-C4 terminal C (WP 0018, Fig-
ure 251) and ground.
3. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
4. Check for active code 2441-04 in
Code 2441-04 Becomes Active -
machine control D6K ECM (WP
Turn ignition switch and battery dis-
connect switch to OFF position (TM 5-
2410-240-10).
Remove jumper wire from WC-C4 ter-
minal C (WP 0018, Figure 251) and
ground.
Replace winch oil pressure sensor
(WP 0136).
Proceed to step 5.
Code 2441-04 Does Not Become
Active - Proceed to Test Step 7.
Code 2441-08 Active - Repeat trou-
5. Using MSD (WP 0016), select
bleshooting code from the beginning.
machine control D6K ECM and
verify 2441-08 is not active.
Code 2441-08 Not Active - Trouble-
shooting complete.
Test Step 7. Test 852-GN Winch
Pressure Sensor Circuit for High
Resistance in Winch Solenoid Wir-
ing Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
0023-259