TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-08 Winch Motor Pres-
2. Disconnect platform wiring har-
sure Sensor Abnormal Fre-
ness connector PL-C5 (WP 0018,
quency, Pulse Width Or
Figure 218) from ECM J2 (WP
Period - Continued
0149).
3. Inspect platform wiring PL-C4 har-
Platform Wiring PL-C4 Harness
ness connector (WP 0018, Figure
Connector Damaged - Replace plat-
217), platform wiring PL-C5 har-
form wiring harness (WP 0155).
ness connector (WP 0018, Figure
Proceed to step 4.
218), and ECM J1 and J2 for
Platform Wiring PL-C5 Harness
damage (WP 0283).
Connector Damaged - Replace plat-
form wiring harness (WP 0155).
Proceed to step 4.
ECM J1 or J2 Damaged - Replace
machine ECM (WP 0149).
Proceed to step 4.
No Problem Found - Connect plat-
form wiring harness connector PL-C5
(WP 0018, Figure 218) on ECM J2
(WP 0149). Connect platform wiring
harness connector PL-C4 (WP 0018,
Figure 217) on ECM J1 (WP 0149).
Proceed to Test Step 4.
4. Using MSD (WP 0016), select
Code 2441-08 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-08 is not active.
Code 2441-08 Not Active - Trouble-
shooting complete.
Test Step 4. Verify If Code 2441-08
Is Still Active
1. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
2. Check for active code 2441-08 in
Code 2441-08 Remains Active - Pro-
machine control D6K ECM.
ceed to Test Step 5.
Code 2441-08 Not Active - Trouble-
shooting complete.
Test Step 5. Test 852 GN Winch
Pressure Sensor Circuit Function
in Machine ECM.
1. Disconnect winch solenoid wiring
harness connector WC-C4 from
winch oil pressure sensor (WP
0018, Figure 251) (WP 0136).
0023-258
