TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-08 Winch Motor Pres-
2. Connect jumper wire between
sure Sensor Abnormal Fre-
WC-C4 terminal B and terminal C
quency, Pulse Width Or
(WP 0018, Figure 251).
Period - Continued
3. Remove right rear access cover
from machine (WP 0191).
4. Disconnect winch solenoid wiring
harness connector WC-C2 (WP
0018, Figure 249) from platform
wiring harness connector PL-C33
(WP 0018, Figure 233) (WP
0137).
5. Using digital multimeter (WP
Resistance Less Than 0.5 Ohms -
0283), measure resistance
Proceed to Test Step 8.
between WC-C2 terminal 7 and
Resistance 0.5 Ohms or Greater -
terminal 8 (WP 0018, Figure 249).
Remove jumper wire from WC-C4 ter-
minal B and terminal C (WP 0018,
Figure 251).
Replace winch solenoid wiring har-
ness (WP 0137).
Proceed to step 6.
6. Using MSD (WP 0016), select
Code 2441-08 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-08 is not active.
Code 2441-08 Not Active - Trouble-
shooting complete.
Test Step 8. Test 852-GN Winch
Pressure Sensor Circuit for High
Resistance in Platform Wiring Har-
ness.
1. Remove jumper wire from WC-C4
terminal B and terminal C (WP
0018, Figure 251).
2. Disconnect platform wiring har-
ness connector PL-C5 (WP 0018,
Figure 218) from ECM J2 (WP
0149).
0023-260