TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2441-08 Winch Motor Pres-
6. Using MSD (WP 0016), select
Code 2441-08 Active - Repeat trou-
sure Sensor Abnormal Fre-
machine control D6K ECM and
bleshooting code from the beginning.
quency, Pulse Width Or
verify 2441-08 is not active.
Code 2441-08 Not Active - Trouble-
Period - Continued
shooting complete.
Test Step 2. Inspect Winch Sole-
noid Wiring WC-C2 Harness Con-
nector and Platform Wiring PL-C33
Harness Connector.
1. Remove right rear access cover
from machine (WP 0191).
2. Disconnect winch solenoid wiring
harness connector WC-C2 (WP
0018, Figure 249) from platform
wiring harness connector PL-C33
(WP 0018, Figure 233) (WP
0137).
3. Inspect winch solenoid wiring
Winch Solenoid Wiring WC-C2 Har-
WC-C2 harness connector (WP
ness Connector Damaged - Replace
0018, Figure 249) and platform
winch solenoid wiring harness (WP
wiring PL-C33 harness connector
0137).
(WP 0018, Figure 233) for dam-
Proceed to step 4.
age (WP 0283).
Platform Wiring PL-C33 Harness
Connector Damaged - Replace plat-
form wiring harness (WP 0155).
Proceed to step 4.
No Problem Found - Connect winch
solenoid wiring harness connector
WC-C2 (WP 0018, Figure 249) on
platform wiring harness connector PL-
C33 (WP 0018, Figure 233) (WP
0137).
Proceed to Test Step 3.
4. Using MSD (WP 0016), select
Code 2441-08 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2441-08 is not active.
Code 2441-08 Not Active - Trouble-
shooting complete.
Test Step 3. Inspect Platform Wiring
PL-C4 and PL-C5 Harness Connec-
tors, and Machine ECM J1 and J2
for Damage.
1. Disconnect platform wiring har-
ness connector PL-C4 (WP 0018,
Figure 217) from ECM J1 (WP
0149).
0023-257