TM 5-2410-240-23-3
0195
CLEANING AND INSPECTION
000195
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK
FUEL TANK GUARD INSTALLATION
000195
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
N OT E
Fuel tank guard weighs approximately 385 lb (175 kg).
1. Install lifting device on fuel tank guard (Figure 7, Item 2).
2. Using lifting device and with assistance, install fuel tank guard (Figure 7, Item 2) on machine (Figure 7, Item 3).
3. Install four washers (Figure 7, Item 1) and bolts (Figure 7, Item 4) on fuel tank guard (Figure 7, Item 2) on
machine (Figure 7, Item 3).
4. Remove lifting device from fuel tank guard (Figure 7, Item 2).
5. Install plate (Figure 8, Item 5), washer (Figure 8, Item 2), chain (Figure 8, Item 4), and bolt (Figure 8, Item 3) on
fuel tank guard (Figure 8, Item 6).
6. Install two washers (Figure 8, Item 7) and bolts (Figure 8, Item 1) on fuel tank guard (Figure 8, Item 6).
Figure 8. Retaining Hardware on Rear of Machine.
0195
