TM 5-2410-240-23-3
0247
REMOVAL CONTINUED
000247
N OT E
Note location of tiedown straps to aid installation.
12. Remove tiedown strap (Figure 6, Item 1) from heater hose (Figure 6, Item 2) and fuel hose (Figure 6, Item 3).
Discard tiedown strap.
13. Remove nut (Figure 6, Item 6), washer (Figure 6, Item 5), inner clamp (Figure 6, Item 9), and outer clamp
(Figure 6, Item 4) from stud (Figure 6, Item 7).
14. Remove inner clamp (Figure 6, Item 9) from heater hose (Figure 6, Item 8).
Figure 6. Heater Hose Retaining Hardware Above Starter and On Flywheel Housing.
0247
15. If arctic kit heater equipped, near right rear of engine and below floor plate, remove two clamps (Figure 7,
Items 2 and 4) and disconnect two heater hoses (Figure 7, Item 1 and 5) from tee (Figure 7, Item 3).
16. If arctic kit heater equipped, set tee (Figure 7, Item 3) with hose aside.
Figure 7. Arctic Kit Heater, Water Inlet Hose and Fittings.
0247
