TM 5-2410-240-23-3
0247
INSTALLATION CONTINUED
000247
26. If arctic kit heater equipped, near right rear of engine and below floor plate, cut heater hose (Figure 24, Item 1).
27. If arctic kit heater equipped, connect two sections of heater hose (Figure 24, Items 1 and 5) to tee (Figure 24,
Item 3) and install two clamps (Figure 24, Items 2 and 4).
Figure 24. Arctic Kit Heater, Water Inlet Hose and Fittings.
0247
N OT E
Install tiedown straps as noted during removal.
28. Install inner clamp (Figure 25, Item 9) on heater hose (Figure 25, Item 8).
29. Install outer clamp (Figure 25, Item 4), inner clamp (Figure 25, Item 9), washer (Figure 25, Item 5), and nut
(Figure 25, Item 6) on stud (Figure 25, Item 7).
30. Install new tiedown strap (Figure 25, Item 1) on heater hose (Figure 25, Item 2) and fuel hose (Figure 25,
Item 3).
Figure 25. Heater Hose Retaining Hardware Above Starter and On Flywheel Housing.
0247