18
TM 5-2410-241-10
OPERATOR MAINTENANCE
-
OPERATION UNDER USUAL CONDITIONS
000
5
Scope; Initial Adjustment Before Use; Mounting and Dismounting; Seat, Seat Belt, and Mirror
Adjustments; Engine Starting and Machine Warm-Up; Stopping Machine; Stopping Engine; Leaving
Machine; Machine OperationTransmission, Speed, and Steering Controls; Gear Selection; Bulldozer
Blade Operation; Winch Operation; Ripper Operation; Lower Digital Display Window; Machine Warning
Summaries
INITIAL SETUP
References
0
0
TB 43-0142
0
0
0
0
SCOPE
0005
This work package provides instructions on operating the D7R Dozer, Type I with Winch and Type II with Ripper,
under usual conditions. Refer to WP 0006 for operating instructions under unusual conditions. Before, during, and
after operation, perform applicable Operator Preventive Maintenance Checks and Services (PMCS) (WP 0012).
INITIAL ADJUSTMENT BEFORE USE
0005
Perform all Before Operator PMCS procedures (WP 0012).
Turn battery disconnect switch to ON position (WP 0004).
MOUNTING AND DISMOUNTING
0005
WARN I N G
Mount and dismount the machine only atlocations with steps and grab handles.
Clean steps and grab handles prior to mounting machine.
Face machine during mounting and dismounting.
Maintain three-point contact (two hands and one foot, or one hand and two feet) at all
times.
Do not mount or dismount a moving machine.
Do not jump off a moving machine.
Do not carry tools or supplies when mounting or dismounting machine.
Do not use any controls as grab han les during mounting or dismounting.
d
Failure to follow these warnings may result in injury or death to personnel.
1. Open left door.
2. Enter machine from left side and occupy operator's seat.
3. Close left door.
END OF TASK
0005-1
