TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
168-4 Electrical System Volt-
46. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
age Below Normal - Contin-
0296), test for continuity between
to step 47.
ued
pin 31 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
all other pins in powertrain ECM
0178). Replace ECM Fuse #19
connector X-C2 (WP 0018, Figure
(TM 5-2410-241-10). Ensure all
4).
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
47. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 48.
pin 31 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
machine ground.
0178). Replace ECM Fuse #19
(TM 5-2410-241-10). Ensure all
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
48. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 49.
pin 31 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
all pins in powertrain ECM connec-
0178). Replace ECM Fuse #19
tor X-C 3 (WP 0018, Figure 3).
(TM 5-2410-241-10). Ensure all
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
49. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 50.
pin 38 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
all other pins in powertrain ECM
0178). Replace ECM Fuse #19
connector X-C2 (WP 0018,
(TM 5-2410-241-10). Ensure all
Figure 4).
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
50. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 51.
pin 38 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
machine ground.
0178). Replace ECM Fuse #19
(TM 5-2410-241-10). Ensure all
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
0020-18