TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
177-3 Transmission Oil Tem-
16. Using a digital multimeter (WP
1. If continuity is found, proceed to
perature Sensor (Sump)
0296), test for continuity between
step 17.
Voltage Above Normal -
pin 2 on transmission oil tempera-
2. If continuity is NOT found, replace
Continued
ture sensor connector V-C8 (WP
engine harness (WP 0055).
0018, Figure 46) and pin 35 on
Ensure all harness connectors are
engine harness (engine to plat-
reconnected. Verify correct opera-
form) connector V-C1 (WP 0018,
tion of machine (TM 5-2410-241-
Figure 12).
10).
17. Using a digital multimeter (WP
1. If continuity is found, replace
0296), test for continuity between
engine harness (WP 0055).
pin 38 on engine harness (engine
Ensure all harness connectors are
to platform) connector V-C1 (WP
reconnected. Verify correct opera-
0018, Figure 12) and all other pins
tion of machine (TM 5-2410-241-
in engine harness (engine to plat-
10).
form) connector V-C1 (WP 0018,
2. If continuity is NOT found, proceed
Figure 12).
to step 18.
18. Using a digital multimeter (WP
1. If continuity is found, replace
0296), test for continuity between
engine harness (WP 0055).
pin 35 on engine harness (engine
Ensure all harness connectors are
to platform) connector V-C1 (WP
reconnected. Verify correct opera-
0018, Figure 12) and all other pins
tion of machine (TM 5-2410-241-
in engine harness (engine to plat-
10).
form) connector V-C1 (WP 0018,
2. If continuity is NOT found, proceed
Figure 12).
to step 19.
19. Remove left platform access panel
(WP 0207).
20. Disconnect steering control har-
ness connector X-C1 (WP 0018,
Figure 34) from platform harness
connector MA-C14 (WP 0018,
Figure 33).
21. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 22.
pin 45 on platform harness con-
2. If continuity is NOT found, replace
nector MA-C14 (WP 0018,
platform harness (WP 0209).
Figure 33) and pin 38 on platform
Ensure all harness connectors are
harness (platform to engine) con-
reconnected. Verify correct opera-
nector MA-C22 (WP 0018,
tion of machine (TM 5-2410-241-
Figure 11).
10).
0020-22