TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
177-4 Transmission Oil Tem-
14. Disconnect steering control har-
perature Sensor (Sump)
ness connector X-C1 (WP 0018,
Voltage Below Normal -
Figure 34) from platform harness
Continued
connector MA-C14 (WP 0018,
Figure 33).
15. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 16.
pin 45 on platform harness con-
2.
If continuity is NOT found, replace
nector MA-C14 (WP 0018, Figure
platform harness (WP 0209).
33) and pin 38 on platform har-
Ensure all harness connectors are
ness (platform to engine) connec-
reconnected. Verify correct opera-
tor MA-C22 (WP 0018, Figure 11).
tion of machine (TM 5-2410-241-
10).
16. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 17.
pin 18 on platform harness con-
2.
If continuity is NOT found, replace
nector MA-C14 (WP 0018, Figure
platform harness (WP 0209).
33) and pin 35 on platform har-
Ensure all harness connectors are
ness (platform to engine) connec-
reconnected. Verify correct opera-
tor MA-C22 (WP 0018, Figure 11).
tion of machine (TM 5-2410-241-
10).
17. Using a digital multimeter (WP
1. If continuity is NOT found, proceed
0296), test for continuity between
to step 18.
pin 45 on platform harness con-
2. If continuity is found, replace plat-
nector MA-C14 (WP 0018, Figure
form harness (WP 0209). Ensure
33) and all other pins in platform
all harness connectors are recon-
harness connector MA-C14 (WP
nected. Verify correct operation of
0018, Figure 33).
machine (TM 5-2410-241-10).
18. Using a digital multimeter (WP
1. If continuity is NOT found, proceed
0296), test for continuity between
to step 19.
pin 18 on platform harness con-
2. If continuity is found, replace plat-
nector MA-C14 (WP 0018, Figure
form harness (WP 0209). Ensure
33) and all other pins in platform
all harness connectors are recon-
harness connector MA-C14 (WP
nected. Verify correct operation of
0018, Figure 33).
machine (TM 5-2410-241-10).
19. Disconnect powertrain ECM con-
nector X-C2 (WP 0018, Figure 4)
from ECM.
20. Disconnect powertrain ECM con-
nector X-C3 (WP 0018, Figure 3)
from ECM.
0020-26