TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
177-4 Transmission Oil Tem-
7. Turn ignition switch and battery
perature Sensor (Sump)
disconnect switch to OFF position
Voltage Below Normal -
(TM 5-2410-241-10).
Continued
8. Disconnect engine harness
(engine to platform) connector V-
C1 (WP 0018, Figure 12) from
platform harness (platform to
engine) connector MA-C22 (WP
0018, Figure 11).
9. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 10.
pin 1 on transmission oil tempera-
2. If continuity is NOT found, replace
ture sensor connector V-C8 (WP
engine main harness (WP 0055).
0018, Figure 46) and pin 38 on
Ensure all harness connectors are
engine harness (engine to plat-
reconnected. Verify correct opera-
form) connector V-C1 (WP 0018,
tion of machine (TM 5-2410-241-
Figure 12).
10).
10. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 11.
pin 2 on transmission oil tempera-
2. If continuity is NOT found, replace
ture sensor connector V-C8 (WP
engine main harness (WP 0055).
0018, Figure 46) and pin 35 on
Ensure all harness connectors are
engine harness (engine to plat-
reconnected. Verify correct opera-
form) connector V-C1 (WP 0018,
tion of machine (TM 5-2410-241-
Figure 12).
10).
11. Using a digital multimeter (WP
1. If continuity is found, replace
0296), test for continuity between
engine main harness (WP 0055).
pin 38 on engine harness (engine
Ensure all harness connectors are
to platform) connector V-C1 (WP
reconnected. Verify correct opera-
0018, Figure 12) and all other pins
tion of machine (TM 5-2410-241-
in engine harness (engine to plat-
10).
form) connector V-C1 (WP 0018,
2. If continuity is NOT found, proceed
Figure 12).
to step 12.
12. Using a digital multimeter (WP
1. If continuity is found, replace
0296), test for continuity between
engine main harness (WP 0055).
pin 35 on engine harness (engine
Ensure all harness connectors are
to platform) connector V-C1 (WP
reconnected. Verify correct opera-
0018, Figure 12) and all other pins
tion of machine (TM 5-2410-241-
in engine harness (engine to plat-
10).
form) connector V-C1 (WP 0018,
2. If continuity is NOT found, proceed
Figure 12).
to step 13.
13. Remove left platform access panel
(WP 0207).
0020-25