TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
585-2 Transmission Output
17. Using a digital multimeter (WP
1. If continuity is NOT found, proceed
Speed Sensor #1 Data
0296), test for continuity between
to step 18.
Erratic, Intermittent, or
pin 9 on platform harness connec-
2. If continuity is found, replace plat-
Incorrect - Continued
tor MA-C14 (WP 0018, Figure 33)
form harness (WP 0209). Ensure
and all other pins in platform har-
all harness connectors are recon-
ness connector MA-C14 (WP
nected. Verify correct operation of
0018, Figure 33).
machine (TM 5-2410-241-10).
18. Using a digital multimeter (WP
1. If continuity is NOT found, proceed
0296), test for continuity between
to step 19.
pin 8 on platform harness connec-
2. If continuity is found, replace plat-
tor MA-C14 (WP 0018, Figure 33)
form harness (WP 0209). Ensure
and all other pins in platform har-
all harness connectors are recon-
ness connector MA-C14 (WP
nected. Verify correct operation of
0018, Figure 33).
machine (TM 5-2410-241-10).
19. Disconnect transmission jumper
harness connector MP-C1 (WP
0018, Figure 55) from transmis-
sion harness connector P-C1 (WP
0018, Figure 56).
20. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 21.
pin 9 on transmission jumper har-
2. If continuity is NOT found, replace
ness connector MP-C2 (WP 0018,
transmission jumper harness (WP
Figure 54) and pin H on transmis-
0169). Ensure all harness connec-
sion jumper harness connector
tors are reconnected. Verify cor-
MP-C1 (WP 0018, Figure 55).
rect operation of machine (TM 5-
2410-241-10).
21. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 22.
pin 10 on transmission jumper har- 2.
If continuity is NOT found, replace
ness connector MP-C2 (WP 0018,
transmission jumper harness (WP
Figure 54) and pin A on transmis-
0169). Ensure all harness connec-
sion jumper harness connector
tors are reconnected. Verify cor-
MP-C1 (WP 0018, Figure 55).
rect operation of machine (TM 5-
2410-241-10).
22. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 23.
pin 10 on transmission jumper har- 2.
If continuity is found, replace
ness connector MP-C2 (WP 0018,
transmission jumper harness (WP
Figure 54) and all other pins in
0169). Ensure all harness connec-
transmission jumper harness con-
tors are reconnected. Verify cor-
nector MP-C2 (WP 0018, Figure
rect operation of machine (TM 5-
54).
2410-241-10).
0020-90