TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
689-5 Left Brake Solenoid
1. Connect MSD (WP 0016), select
1. If active 689-5 code is present,
Voltage Below Normal
Powertrain D7 ECM, and check for
proceed to step 2.
Diagnostic Codes or Event Codes
2. If no active codes are present, the
problem does NOT exist at this
time. Resume normal operation.
2. Remove rear floor plate (WP
0231).
3. Disconnect platform harness left
brake solenoid connector MA-C12
(WP 0018, Figure 67) from left
brake solenoid (WP 0018,
Figure 68).
4. Install a jumper wire between pins
1 and 2 on platform harness left
brake solenoid connector MA-C12
(WP 0018, Figure 67).
5. Check for Diagnostic Codes or
1. If active 689-6 code is present,
Event Codes (WP 0013).
Replace left brake solenoid (WP
0147). Ensure all harness connec-
tors are reconnected. Verify cor-
rect operation of machine (TM 5-
2410-241-10).
2. If active 689-5 is present, proceed
to step 6.
6. Remove left platform access panel
(WP 0207).
7. Disconnect powertrain ECM con-
nector X-C2 (WP 0018, Figure 4)
from the powertrain ECM.
8. Disconnect platform harness con-
nector MA-C14 (WP 0018, Figure
33) from steering control harness
connector X-C1 (WP 0018,
Figure 34).
9. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 10.
pin 58 on powertrain ECM connec- 2.
If continuity is NOT found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
pin 37 on steering control harness
0178). Ensure all harness connec-
connector X-C1 (WP 0018,
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).