TM 5-2410-241-23-1
0021
Table 2. Chassis Troubleshooting Procedures - Continued.
0021
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
882-6 Hydraulic Lockout
11. Using digital multimeter (WP
1. If continuity is found, replace
Solenoid Current Below
0296), test for continuity between
chassis harness (WP 0172).
Normal - Continued
pin 1 on chassis harness imple-
Ensure all harness connectors
ment lockout solenoid connector
are reconnected. Verify correct
L-C4 (WP 0018, Figure 90) and
operation of machine (TM 5-2410-
all other pins in chassis harness
241-10).
implement lockout solenoid con-
2. If continuity is NOT found, pro-
nector L-C4 (WP 0018,
ceed to step 12.
Figure 90).
12. Remove left platform access
panel (WP 0212).
13. Disconnect steering harness con-
nector X-C1 (WP 0018, Figure 34)
from platform harness connector
MA-C14 (WP 0018, Figure 33).
14. Remove upper right access panel
(WPN 0184).
15. Disconnect RH console harness
connector R-C1 (WP 0018, Figure
14) from RH platform harness
connector MA-C1 (WP 0018,
Figure 15).
16. Using digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 17.
pin 1 on platform harness connec- 2.
If continuity is NOT found, replace
tor MA-C17 (WP 0018, Figure 85)
platform harness (WP 0209).
and pin 51 on platform harness
Ensure all harness connectors
connector MA-C14 (WP 0018,
are reconnected. Verify correct
Figure 33).
operation of machine (TM 5-2410-
241-10).
17. Using digital multimeter (WP
1.
If continuity is NOT found, pro-
0296), test for continuity between
ceed to step 18.
pin 51 on platform harness con-
2.
If continuity is found, replace plat-
nector MA-C14 (WP 0018,
form harness (WP 0209). Ensure
Figure 33) to all other pins in plat-
all harness connectors are recon-
form harness connector MA-C14
nected. Verify correct operation of
(WP 0018, Figure 33).
machine (TM 5-2410-241-10).
18. Using digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 19.
pin 51 on platform harness con-
2. If continuity is NOT found, replace
nector MA-C14 (WP 0018, Figure
platform harness (WP 0209).
33) and pin 11 on RH platform
Ensure all harness connectors
harness connector MA-C1 (WP
are reconnected. Verify correct
0018, Figure 15).
operation of machine (TM 5-2410-
241-10).
0021-46