TM 5-2410-241-23-1
0021
Table 2. Chassis Troubleshooting Procedures - Continued.
0021
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
882-5 Hydraulic Lockout
9. Remove jumper wire from chassis
Solenoid Current Below
harness implement lockout sole-
Normal - Continued
noid connector L-C4 (WP 0018,
Figure 90) between pin 1 and 2.
10. Remove right hydraulic tank
access panel (WP 0186).
11. Disconnect platform harness con-
nector MA-C17 (WP 0018, Figure
85) from chassis harness connec-
tor L-C1 (WP 0018, Figure 84)
(WP 0177).
12. Using digital multimeter (WP
1. If continuity is NOT found, replace
0296) test for continuity between
chassis harness (WP 0172).
pin 1 on chassis harness imple-
Ensure all harness connectors
ment lockout solenoid connector
are reconnected. Verify correct
L-C4 (WP 0018, Figure 90) and
operation of machine (TM 5-2410-
pin 1 on chassis harness connec-
241-10).
tor L-C1 (WP 0018, Figure 84).
2. If continuity is found, proceed to
step 13.
13. Using digital multimeter (WP
1. If continuity is found, replace
0296) test for continuity between
chassis harness (WP 0172).
pin 1 on chassis harness imple-
Ensure all harness connectors
ment lockout solenoid connector
are reconnected. Verify correct
L-C4 (WP 0018, Figure 90) and
operation of machine (TM 5-2410-
pin 2 on chassis harness imple-
241-10).
ment lockout solenoid connector
2. If continuity is NOT found, pro-
L-C4 (WP 0018, Figure 90).
ceed to step 14.
14. Remove left platform access
panel (WP 0212).
15. Disconnect steering harness con-
nector X-C1 (WP 0018, Figure 34)
from platform harness connector
MA-C14 (WP 0018, Figure 33).
16. Remove upper right platform
access panel (WP 0184).
17. Disconnect RH console harness
connector RW-C1 (WP 0018, Fig-
ure 14) from RH platform harness
connector MA-C1 (WP 0018,
Figure 15).
0021-41