TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
All Windshield Wipers and
55. Using digital multimeter (WP
1.
If continuity is NOT found, pro-
Washers Do NOT Oper-
0296), test for continuity between
ceed to step 56.
ate - Continued
pin 6 on left door wiper motor pig- 2.
If continuity is found, replace Fuse
tail connector (WP 0018, Figure
#1 (TM 5-2410-241-10) and left
185) and ground.
door wiper motor (WP 0250).
Ensure all harness connectors
are reconnected. Verify correct
operation of machine (TM 5-2410-
241-10).
56. Using digital multimeter (WP
1. If continuity is NOT found, pro-
0296), test for continuity between
ceed to step 57.
pin 6 on right door wiper motor
2. If continuity is found, replace Fuse
pigtail connector (WP 0018, Fig-
#1 (TM 5-2410-241-10) and right
ure 186) and ground.
door wiper motor (WP 0250).
Ensure all harness connectors
are reconnected. Verify correct
operation of machine (TM 5-2410-
241-10).
57. Using digital multimeter (WP
1. If continuity is NOT found, replace
0296), test for continuity between
Fuse #1 (TM 5-2410-241-10) and
pin 6 on rear wiper motor pigtail
headliner harness (WP 0232).
connector (WP 0018, Figure 187)
Ensure all harness connectors
and ground.
are reconnected. Verify correct
operation of machine (TM 5-2410-
241-10).
2. If continuity is found, replace Fuse
#1 (TM 5-2410-241-10) and rear
wiper motor (WP 0223). Ensure
all harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
58. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
59. Swap left door wiper switch and
front wiper switch (WP 0234).
60. Replace Fuse #1 (TM 5-2410-
241-10).
61. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).
0022-52