TM 5-2410-241-23-2
0085
INSTALLATION CONTINUED
C AU T I O N
When installed, bearing joint must not be more than 15 degrees off center of bottom of
bore on hydraulic pump adapter. Failure to follow this caution may result in damage to
equipment.
N OT E
Step 5 installs bearing on one hydraulic pump adapter. Repeat procedure to install bearing
on other hydraulic pump adapter.
5. Position oil passage (Figure 12, Item 4) on hydraulic pump adapter (Figure 12, Item 1) downward.
6. Install new bearing (Figure 12, Item 2) with joint (Figure 12, Item 3) at bottom of bore (Figure 12, Item 6) on
hydraulic pump adapter (Figure 12, Item 1).
7. Recess bearing (Figure 12, Item 2) 0.138 0.020 in. (3.5 0.5 mm) from inside edge of bore (Figure 12,
Item 5) on hydraulic pump adapter (Figure 12, Item 1).
Figure 12. Bearing Installation on Hydraulic Pump Adapter.
0085