TM 5-2410-241-23-2
0134
ASSEMBLY
000134
N OT E
Install seal as noted during removal.
1. Install new seal (Figure 7, Item 5) on track adjuster cylinder (Figure 7, Item 4).
2. Install piston (Figure 7, Item 6) on track adjuster cylinder (Figure 7, Item 4).
3. Install new O-ring (Figure 7, Item 11), relief valve (Figure 7, Item 3), and fill valve (Figure 7, Item 8) on track
adjuster cylinder (Figure 7, Item 4).
4. Install plate (Figure 7, Item 7), two washers (Figure 7, Item 1), and bolts (Figure 7, Item 2) on track adjuster
cylinder (Figure 7, Item 4).
5. Install new O-ring (Figure 7, Item 10) and plug (Figure 7, Item 9) on track adjuster cylinder (Figure 7, Item 4).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause injury or death to personnel.
N OT E
Track adjuster weighs approximately 95 lb (43 kg).
6. With assistance, install track adjuster (Figure 8, Item 1) on track adjuster frame (Figure 8, Item 2).
7. Install two stops (Figure 8, Item 5), four washers (Figure 8, Item 3), and bolts (Figure 8, Item 4) on track
adjuster frame (Figure 8, Item 2).
Figure 8. Track Adjuster.
0134