TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0001-05 Cylinder #1 Injector Current
3. Install jumper wire at E-C12
Below Normal - Continued
(WP 0018, Figure 111) har-
ness connector terminal 3 and
terminal 4.
4. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
5. Start engine or attempt to start
engine (TM 5-2410-240-10).
6. At MSD, check that diagnostic
0001-06 Becomes Active - ECM
code 0001-06 is active (WP
and engine control wiring harness
are OK, proceed to Test Step 3.
0001-05 Remains Active - Pro-
ceed to step 7.
7. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
8. Leave jumper wire at E-C12
(WP 0018, Figure 111) har-
ness connector between ter-
minal 3 and terminal 4 in
place.
9. Disconnect ECM harness con-
nector E-C1 (WP 0018, Figure
102) from engine ECM J2.
10. Using digital multimeter
Continuity - ECM faulty. Replace
(WP 0283), test for continuity
engine ECM (WP 0049).
at engine ECM harness con-
Remove jumper wire from E-C12
nector E-C1 (WP 0018,
(WP 0018, Figure 111) terminal 3
Figure 102) between terminal
and terminal 4.
35 and terminal 57.
Connect E-C12 (WP 0018,
Figure 111) to H-C1 (WP 0018,
Figure 174) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
0019-11