TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0001-05 Cylinder #1 Injector Current
WARN I N G
Below Normal
Electrical shock hazard. Electronic unit injector system uses 67-
73 Volts. Failure to follow this warning may result in injury to per-
sonnel.
Test Step 1: Test Fuel Injector
and Engine Control Wiring Har-
nesses.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct the problem and verify diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K.
2. Start engine or attempt to start
engine (TM 5-2410-240-10).
3. At MSD, check if all three
0001-05, 0002-05, and 0003-05
diagnostic codes: 0001-05,
Diagnostic Codes are Active -
0002-05, and 0003-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
4. At MSD, check if all three
0004-05, 0005-05, and 0006-05
diagnostic codes: 0004-05,
Diagnostic Codes are Active -
0005-05, and 0006-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
0001-05 Only Active - Proceed to
Test Step 2.
Test Step 2: Isolate Problem
with Engine Control Wiring Har-
ness.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Disconnect E-C12 (WP 0018,
Figure 111) harness connector
from H-C1 (WP 0018, Figure
174) at valve cover base.
