TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0174-03 Fuel Temperature Sensor
Voltage Above Normal Continued
Wait at least 30 seconds for diagnostic codes to become active.
6. Using MSD (WP 0016), select
0174-03 Remains Active -
engine ECM C6.6 D6K, and
Proceed to Test Step 4.
check if diagnostic code 0174-
0174-04 Becomes Active - Fuel
03 is active.
filter link harness open. Replace
fuel filter link harness (WP 0071).
Remove jumper wire from termi-
nals 1 and 4 on E-C19 (WP 0018,
Figure 115).
Connect E-C19 (WP 0018,
Figure 115) to FF-C1 (WP 0018,
Figure 147).
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 4: Test Harness Sig-
nal Circuit.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Leave jumper wire at terminals
1 and 4 on engine harness to
filter link harness connector E-
C19 (WP 0018, Figure 115) in
place.
3. Disconnect engine ECM har-
ness connector E-C1
(WP 0018, Figure 102) from
the engine ECM J2.
0019-82