TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0174-03 Fuel Temperature Sensor
4. Using digital multimeter
Continuity - ECM faulty. Replace
Voltage Above Normal Continued
(WP 0283), test for continuity
engine ECM (WP 0049).
between engine harness to fil-
Remove jumper wire from termi-
ter link harness connector E-
nals 1 and 4 on E-C19 (WP 0018,
C19 (WP 0018, Figure 115)
Figure 115).
terminal 1 and ECM harness
Connect E-C19 (WP 0018,
connector E-C1 (WP 0018,
Figure 115) to FF-C1 (WP 0018,
Figure 102) terminal 54.
Figure 147).
Connect FF-C4 (WP 0018,
Figure 150) to prime pump temper-
ature sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052).
Remove jumper wire from termi-
nals 1 and 4 on E-C19 (WP 0018,
Figure 115).
Connect E-C19 (WP 0018,
Figure 115) to FF-C1 (WP 0018,
Figure 147).
Connect FF-C4 (WP 0018,
Figure 150) to prime pump temper-
ature sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 5: Test Harness 5-Volt
and Return Circuit.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect engine harness to
filter link harness connector E-
C19 (WP 0018, Figure 115)
from filter link harness to
engine harness connector FF-
C1 (WP 0018, Figure 147).
0019-83