TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0190-08 Engine Speed Sensor
Abnormal Frequency, Pulse Width,
If signal from secondary speed/timing sensor is also lost, engine
or Period
will shut down.
ECM will use signal from seco dary speed/timing sensor.
n
Test Step 1: Test Signal Circuit.
N OT E
Always inspect harness connectors that are involved in the
circuit. Poor connections can often be the cause of an electrical
circuit problem. Verify that all connections in the circuit are clean
and secure, and connections are in good condition. If a problem
with connection is found, correct the problem and verify
diagnostic code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K.
2. Start and run engine (TM 5-
2410-240-10), and verify
0190-08 is active.
3. Turn ignition switch to OFF
position (TM 5-2410-240-10).
4. Disconnect E-C4 (WP 0018,
Figure 105) harness connec-
tor from engine speed (crank
position) sensor.
5. Turn ignition switch to ON
position (TM 5-2410-240-10).
6. Using digital multimeter
Voltage OK (7.2 - 8.8-Volts) - Pro-
(WP 0283), measure for volt-
ceed to step 7.
age between E-C4 (WP 0018,
Voltage Less Than 7.2 Volts -
Figure 105) harness connec-
Proceed to Test Step 2.
tor terminal 1, and ground.
7. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
8. Disconnect engine ECM har-
ness connector E-C1
(WP 0018, Figure 102) from
engine ECM J2.