TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0262-04 5 Volt Sensor DC
6. Disconnect platform harness to
Supply Voltage Below Nor-
chassis harness connector PL-
mal - Continued
C18 (WP 0018, Figure 226) from
chassis harness to platform har-
ness connector CH-C1 (WP 0018,
Figure 81).
7. Using digital multimeter (WP
Continuity - Proceed to step 8.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 23 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 1
Verify proper operation of machine
on chassis harness travel pres-
(TM 5-2410-240-10).
sure sensor connector CH-C9
(WP 0018, Figure 88).
8. Using digital multimeter (WP
No Continuity - Proceed to step 9.
0283), test for continuity between
Continuity - Replace chassis harness
pin 23 on chassis harness to plat-
(WP 0153, WP 0154). Ensure all har-
form harness connector CH-C1
ness connectors are reconnected.
(WP 0018, Figure 81) and all
Verify proper operation of machine
other pins on chassis harness to
(TM 5-2410-240-10).
platform harness connector CH-
C1 (WP 0018, Figure 81).
9. Disconnect platform harness
ECM J1 connector PL-C4 (WP
0018, Figure 217) from machine
ECM (WP 0147, WP 0149).
10. Using digital multimeter (WP
Continuity - Proceed to step 11.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 11 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 23 on plat-
reconnected. Verify proper operation
form harness to chassis harness
of machine (TM 5-2410-240-10).
connector PL-C18 (WP 0018, Fig-
ure 226).
11. Using digital multimeter (WP
No Continuity - Proceed, to step 12.
0283), test for continuity between
Continuity - Replace platform wiring
pin 11 on platform harness ECM
harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and all other pins on
reconnected. Verify proper operation
platform harness ECM J1 connec-
of machine (TM 5-2410-240-10).
tor PL-C4 (WP 0018, Figure 217).
12. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from machine
ECM (WP 0147, WP 0149).
0020-43