TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0262-04 5 Volt Sensor DC
13. Using digital multimeter (WP
No Continuity - Replace machine
Supply Voltage Below Nor-
0283), test for continuity between
ECM (WP 0147, WP 0149). Ensure all
mal - Continued
pin 11 on platform harness ECM
harness connectors are reconnected.
J1 connector PL-C4 (WP 0018,
Verify proper operation of machine
Figure 217) and all other pins on
(TM 5-2410-240-10).
platform harness ECM J2 connec-
Continuity - Replace platform wiring
tor PL-C5 (WP 0018, Figure 218).
harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
0291-03 Engine Cooling Fan
Solenoid Voltage Above Nor-
Always inspect harness connectors that are involved in circuit. Poor
mal
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with a connection is found, correct
the problem and verify that this diagnostic code is active before
performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0262-03 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect engine harness
demand fan solenoid connector
EN-C18 (WP 0018, Figure 135)
from demand fan solenoid (WP
0199)
4. Disconnect platform harness to
engine harness connector PL-
C32 (WP 0018, Figure 232) from
engine harness to platform har-
ness connector EN-C50 (WP
0018, Figure 140).
5. Disconnect platform harness to
engine harness connector PL-
C15 (WP 0018, Figure 225) from
engine harness to platform har-
ness connector EN-C15 (WP
0018, Figure 132).