TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1707-05 Proportional Sole-
3. Disconnect pump harness LH
noid Valve (Left Drive Motor)
drive motor solenoid connector
Current Below Normal -
CH-C8 (WP 0018, Figure 87) from
Continued
LH drive motor solenoid.
4. Install a jumper wire between pins
1 and 2 on pump harness LH
drive motor solenoid connector
CH-C8 (WP 0018, Figure 87).
1707-05 Code Active - Proceed to
5. Check for diagnostic codes (WP
step 6.
1707-06 Code Active - Replace LH
drive motor solenoid (WP 0128).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
6. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
7. Disconnect chassis harness to
platform harness connector CH-
C1 (WP 0018, Figure 81) from
platform harness to chassis har-
ness connector PL-C18 (WP
0018, Figure 226).
8. Using digital multimeter (WP
Continuity - Proceed, to step 9.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 29 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 1
Verify proper operation of machine
on pump harness LH drive motor
(TM 5-2410-240-10).
solenoid connector CH-C8 (WP
0018, Figure 87).
9. Using digital multimeter (WP
Continuity - Proceed to step 10.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 17 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 2
Verify proper operation of machine
on pump harness LH drive motor
(TM 5-2410-240-10).
solenoid connector CH-C8 (WP
0018, Figure 87).
0020-118